DCC Concept accessory decoder

Post Reply
RC06
Posts: 2
Joined: Tue Dec 04, 2018 8:57 pm
Contact:

DCC Concept accessory decoder

#1

Post by RC06 » Tue Dec 04, 2018 9:47 pm

I have DCC Concept AD4fx accessory decoders and Gaugemaster BPPM10 Point Motors. The output on the decoder for wiring the motor is 2 wire + & - The input on the point motors are three wires + C - Should i use just the poss & neg on the motors or should i use the decoder output for momentary switching which hqs the three wires + C -

Ron S
Posts: 16
Joined: Thu Oct 04, 2018 11:48 pm
Contact:

Re: DCC Concept accessory decoder

#2

Post by Ron S » Tue Dec 04, 2018 10:40 pm

from what I read re the Gaugemaster BPPM10 is 3 terminals - one for each coil plus a common but the AD4fx is for stall motors like cobalt & Tortoise not solenoids
https://www.dccconcepts.com/product/cob ... ay-output/
so for solenoids, you need a ADS-2fx accessory decoder

https://www.dccconcepts.com/manual/owne ... y-decoder/
Ron

NCE DCC, 00 scale, very loosely based on GWR

RC06
Posts: 2
Joined: Tue Dec 04, 2018 8:57 pm
Contact:

Re: DCC Concept accessory decoder

#3

Post by RC06 » Wed Dec 05, 2018 12:37 am

Thanks Ron, realise my mistake now and will change the decoders for solenoid type

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest