point problem

Post Reply
bobclifford1953
Posts: 47
Joined: Sat Nov 03, 2018 11:49 am
Location: wolverhampton
Contact:

point problem

#1

Post by bobclifford1953 »

hi guys i getting on well with the rewire on my layout upgrading the bus and droppers but i am having a problem with two points they will throw only one way i have tried a new switch and the result is the same they are peco side mounted motors when i try them on any other point wires the motors work normally any help with this problem will be most welcome as its got me stumped regards bob :!: :!: :!:
brian1951
Site Admin
Posts: 896
Joined: Thu Oct 04, 2018 5:52 pm
Location: Welsh Borders.
Contact:

Re: point problem

#2

Post by brian1951 »

Check your wiring Bob, Peco use Red and Black for left and right and Green for the return unlike Hornby. See diagram here. https://www.brian-lambert.co.uk/Electrical_Page_2.html scroll down to Peco point motor.
bobclifford1953
Posts: 47
Joined: Sat Nov 03, 2018 11:49 am
Location: wolverhampton
Contact:

Re: point problem

#3

Post by bobclifford1953 »

hi brian i have replaced the wiring on these problem points and they now work well good job it happened while i am rewiring for dcc cos of the position of the points it would have been a bit of a job to do thanks for your help with this problem best regards bob :) :) :)
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests