View Single Post
Old 01-06-2016, 02:30 PM   #7
Flashbang's Avatar

Join Date: Jul 2009
Location: SE UK
Posts: 8,410
Flashbang will become famous soon enough

Seeps are quite simple to wire... One side of the supply or the CDU + positive output to the operation switches middle wiring tag, linking one switch to the next middle tags. Each switches outer wiring tags to the Seeps 'A' & 'B' connections. Seep 'C' connection to the supplies other terminal or the CDU - negative output, where a CDU is used.

Moving the switch one way applies the power to one coil. Operate the switch to the other side aplies power to the other coil.

Toggle switches must be sprung to centre off (On)-Off-(On) type, or use two press to make momentary non locking push buttons. Passing contact levers or stud and probe.

Wire throughout in at least 16/0.2mm equipment wire for reliable operation.
Broken? It was working when I left it!
Flashbang is offline   Reply With Quote